This tool is intended to automate the process of driving nails. This model equipped with pneumatic drive, i.e. to use it you need a compressor. The working pressure of the tool is declared in the range from 0.4 MPa or about 4 atmospheres to 0.7 MPa or about 7 atmospheres. The fitting in the device is a quick-detachable Japanese model, while, judging by the reviews, the seller can also send a European connector. Note that the “native” fitting on the tool is sealed with a sealant, so that there may be problems with its dismantling, and therefore, if desired, you can additionally order a compressor hose with suitable connections recommended by the seller. Its different sizes are presented in this lot.
The clip of the nailing gun is designed for 100 nails. Device works with nails like F10, F15, F20, F25 and F30. It is important to understand that this tool only clogs nails and pins. An analog designed for clogging staples can be purchased here. This tool also provides the ability to control the driving depth - you need to loosen the two screws under the hexagon on the nose and pull it out or push it in.
The tool is equipped with two hex keys, while nails are not included. Suitable fasteners of the required length can be purchased both offline and this lots.
A fairly high-quality tool that copes well with its tasks, and, importantly, at a very reasonable price. Build quality of the gun at a high level. The device is quite compact (180 mm x 205 mm) and light (weight about 1100 gr.), In addition, the handle is covered with material under the skin and thanks to this the tool can be held with one hand without much difficulty. We also note that before starting work, it is necessary to drip a few drops of oil into the air duct.
Cost: ~ 1772