This is intended device for mechanization of the process of filing metals, wood, plastics and other relatively hard materials. To use it, you need a compressor. The fitting in the fixture is a quick-release Japanese standard. The tool does not require a compressor hose, as it is out of the box equipped with a built-in sleeve 380 mm long. The device itself is quite compact - its length is only 160 mm, the width of the handle is 26 mm. The file weight is also quite insignificant - 457 g. The body of the device is entirely made of metal, which makes it sufficiently resistant to external influences. In the place of contact with the hand, anti-slip notches are applied to the surface of the tool. The handle of the device is additionally equipped with a mechanism for protection against accidental activation. So, to start work, you must slide the safety tab. The diameter of the hole for the canvas is 5 mm. Other files or files with a suitable shank diameter can also be clamped into the tool. Before starting work, it is recommended to add a little oil to the duct.
The characteristics of the device are as follows:
• idle speed: 6000 rpm;
• stroke: 5 mm;
• working pressure: from 0.5 MPa (~ 5 atmospheres) to 0.7 MPa (~ 7 atmospheres);
• Average air flow: 3.5 CFM (0.099 m³ / min).
The toolkit comes with 4 canvases: flat, triangular, round, semicircular (shank length - 30 mm, working part length - 125 mm), Allen key and removable stop (the depth of its fit can be adjusted). The whole set is delivered in a company box made of thick cardboard. If necessary, order identical canvases here.
Compact and at the same time functional device that can greatly facilitate the work of files, especially in hard-to-reach places.
Cost: ~ 3142