In this article, the master will tell us how to make a fence from a burnt board. To make such a fence, you need the following
Tools and materials:
- Boards - boards can be old, with knots and flaws. The master uses cedar boards.
Propane burner
-Water (just in case of fire)
-Compressor (for safety reasons and for blowing boards after burning)
-Kozly (toaboutevil, not goats)
- Brush with soft bristles (if you need to remove the charred layer, then with wire bristles)
- Flaxseed oil (according to the master - this is the best tool for decoration in this case)
-Retosh
-Personal protective equipment
-Circular Saw
-Clips
- Paint roller
The boards that the master decided to use for the fence are not new, they are more than 10 years old. The master cleans them with a brush. Cuts to size.
Then he places the boards on the goats and starts firing. On each side, the master spent about 10 minutes. The boards will smoke and crack when they ignite, you can douse them with water.
After firing, the master brushes the ash from the boards with a brush. Blows boards with air. Washes them. After washing, leaves to dry.
In principle, even in this form, the boards are already ready.
For a better look and protection, the master covers the boards with linseed oil. Then again, lightly, processes the boards with a burner. This operation will burn excess oil. Then leaves the boards for a week.
After a week, the boards do not leave any marks on their hands, neither oily nor ash. Now you can assemble and install the fence.