Recently on our site was published material on the manufacture stabilizer for the camera from ordinary PVC pipes. We continue this topic. In this article, we will review another video on the topic of stabilizers for cameras, presenting you with another no less effective design, which will again be made of PVC pipes.
First of all, we suggest devoting a few minutes to watching the video
So we need:
- 3 20 centimeter pieces of PVC pipe;
- 2 16 centimeter pieces of PVC pipe;
- 2 8 centimeter pieces of PVC pipe;
- 9 3 centimeter pieces of PVC pipe;
- 6 knees at 90 degrees;
- 6 knees at 45 degrees;
- 2 tees
First we need to make two stabilizer knobs. To do this, take two 20 cm pieces and 2 elbows at 45 degrees. We warm in a circle the tip of the first pipe on a gas stove or burner and put on a knee. Repeat the same with the second piece.
We stick one 3 cm piece of pipe into the second holes on the knees of the handles.
We take one T-shaped tee and stick into the side holes one 3 cm piece of pipe.
After that, insert the elbow 45 degrees into one side 3 cm piece on the tee so that the third hole of the tee is in an upright position. Repeat the same with the second 3 cm piece.
Now you need to stick the handles into the holes remaining on the lap. On this, the front of the stabilizer is ready. You can begin to make a stand for the shoulder.
We start by connecting the two knees to each other 90 degrees, putting one 3 cm piece of pipe between them.
Next, you need to take 2 knees at 45 degrees and stick them in one 3 cm piece.
We put 2 knees at 45 degrees into the structure, which was made from knees at 90 degrees.
In the remaining holes on the knees of 45 degrees, we insert a 16-centimeter piece of pipe, thus obtaining a substrate on the shoulder.
We take one tee and shove it into the second end of a 16 centimeter piece. Now you need to close the design of the substrate, for which we connect the tee and the second 16 cm pipe with a 90 degree elbow. Poke another 16 cm piece into the third hole of the tee.
We take one 8 cm piece and put on each tip along the knee 90 degrees so that these knees are directed in opposite directions.
We insert this part onto the substrate at an angle.
Again we take the front part, which was made in the beginning. In the middle part there is one free hole in which you need to stick a 3 cm piece and a knee 90 degrees.
We connect the front of the stabilizer with a substrate for the shoulder.
Such a stabilizer can be used not only for the camera, but also for a mobile phone. If you need to shoot on camera, then on the pipe connecting the front part to the substrate, you just need to screw the bolt. And if you need to shoot a mobile phone with a camera, you can take an old and unnecessary plastic case and stick it on the same pipe with a glue gun.
Finally, you can take care of the aesthetic side homemade. To do this, you can paint the stabilizer with spray paint. If desired, you can also rewind the shoulder pad with electrical tape to make it softer.
