Tracked all-terrain vehicle Tazik-2. Builder caterpillar Alexey from Khanty-Mansiysk.
Layout car making.
The Toyota 7A-FE engine is 115 hp, the torque is 155n \ m at 2800 rpm.
Gearbox gearbox VAZ-2101, four-speed gear shift.
Differential rotation using a bridge from the VAZ-2101.
Suspension 1 wheel independent, 2-3 balancer.
Length 265 cm. Width 175 cm.
The caterpillar is made of a conveyor belt 13 mm thick, 46 cm wide. The tracks are made of extruded profile pipe 40 * 20 * 2 mm, the stops are from a strip 30 * 4 mm, and are fastened with m8 bolts.
The figure shows the layout.
Disc brakes, sprocket wheel of a pipe with a diameter of 350 mm, made of thick-walled pipe. The thickness of the pipe is 32 mm. machined up to 15 mm.
Suspension of a tension wheel on springs from "Ant".
The balancer is different shoulders. The front is 100 mm longer than the rear.
Calipers and wheels from the VAZ-2108.
The boat is scalded, the weight of the boat was 170 kg.
The bottom is reinforced for engine installation.
The boat is painted, put on wheels.
Suspension assembled.
A heat exchanger from a copper pipe with an outer diameter of 13 mm was soldered into the pallet.
Track tension mechanism.
The scheme of fastening nuts, bolts, locknuts.
The bolt rests on the tensioner carriage and pulls the track, the bolt travel is 80 mm.
The main control levers. Clutch on the pedals, turns the levers, gas on the lever handle.
Plastic canister from a boat for fuel, capacity 42 liters.
Installed engine, gearbox, driveshaft and radiator.
Welded cab frame and installed in place.
The radiator is fixed in place.
The cabin is scalded.
And, finally, the first exit. Dashing, already breathtaking! video
Video from the driver's cab.
All videos about the Tazik-2 all-terrain vehicle. .
Alexey built his Tazik-2 and we wish him success in the further construction of all-terrain vehicles.