» Car DIY »Stand holder for a phone in a car do it yourself

DIY stand holder for a phone in a car

DIY stand holder for a phone in a car


Offered for construction, a car phone stand will be extremely useful for drivers who often use the phone. She will solve the problem of finding a phone while traveling. Thanks to a simple and reliable design, the work will not take much time.

Step 1. Tools.

To create a rack you will need:
1. Aluminum tube with a diameter of 47 mm "f. 4";
2. Connecting corner tubes at 45 ° and 90 ° (aluminum or copper). They are cheap and sold at any hardware store.




3. Solid wooden sticks (you can take ice cream sticks);
4. Epoxy glue or any other glue with similar qualities;
5. Case or phone case;
6. Cable ties (they will be needed to mount the cover);
7. Hacksaw;
8. The line;
9. The knife.

Step 2. Assembling the frame.
Before you begin, you should determine the location of the telephone rack. It should not interfere with the use of the audio system, recharging and other daily activities in car. Only then can you start measuring.

The aluminum tube must be cut into 3 parts. The shortest part is attached to a 45 ° angle tube. The horizontal part (about 5 cm) connects the corner tubes at 90 ° and 45 ° "f. 2.1 - 2.2". A vertical pipe (approximately 10-13 cm) will hold the stand itself. All tube connections must be lubricated with glue so that nothing falls off during movement.



Step 3. Mount the cover.
On the back of the cover we make 3 pairs of cuts (the depth of the cut should correspond to the tips of the ties). The cuts are parallel to the tube, which will subsequently be attached to the cover. Threaded into the holes of the screed and tightened a little (the main thing is not to overdo it). We tighten the long tube of the frame with ties as shown in the photo. Cut off the ends if they are too long.



Next, you need to cut the wooden sticks in half, insert between the case and the aluminum tube and grease with glue.

Step 4. Fastening.
The last step is to mount the stand to the car. To do this, we attach the connecting tube to the pre-selected installation location of the rack.Now you can not be afraid that the phone or GPS navigator will drop out somewhere or be too far away.

10
10
10

Add a comment

    • smilesmilesxaxaokdontknowyahoonea
      bossscratchfoolyesyes-yesaggressivesecret
      sorrydancedance2dance3pardonhelpdrinks
      stopfriendsgoodgoodgoodwhistleswoontongue
      smokeclappingcraydeclarederisivedon-t_mentiondownload
      heatirefullaugh1mdameetingmoskingnegative
      not_ipopcornpunishreadscarescaressearch
      tauntthank_youthisto_clueumnikacuteagree
      badbeeeblack_eyeblum3blushboastboredom
      censoredpleasantrysecret2threatenvictoryyusun_bespectacled
      shokrespektlolprevedwelcomekrutoyya_za
      ya_dobryihelperne_huliganne_othodifludbanclose

We advise you to read:

Hand it for the smartphone ...