» Fixtures » Instruments »Bucket for picking berries with your own hands

DIY bucket for picking berries


welcome all the inhabitants of our sites!
Autumn has come, which means it's time to take care of the use of vitamins in the cold winter. Therefore, I, in your judgment, present one of the options for the self-made production of a harvester for collecting tasty, fortified, and most importantly useful natural gifts (how this harvester works can be viewed on the YouTube website - the Iskander AP channel).

As usual, the device will be assembled from improvised material: small pieces of plywood, a case from the CD changer (disassembly on the above channel), wire, screws, nylon thread, glue.

For work, we need tools:
- electric jigsaw;
- ruler;
- screwdriver;
- nippers;
- scissors for metal;
- drill;
- hammer;
- marker;
- scissors.


Before assembling the device, we will depict an approximate scheme in which the dimensions can be purely individual.

We mark the wooden parts of the combine on plywood.

Using an electric jigsaw, we cut out the parts for the upper and rear of the combine.
We cut the blank for the handle in half for further work with it.

We glue the blanks for the handle using wood glue.



Using clamps we fasten the glued parts.


After the glue dries, we cut out the handle with an electric jigsaw. We clean the handle with sandpaper to round off sharp edges.

Mark the template for the side walls.


Cut it out.

Using the prepared template, we do the marking on metal blanks.

Scissors for metal cut parts for the side walls of the combine.

Along the perimeter of the sidewalls, drill holes for screws.
The result is something like this.

Next, proceed to the bottom, main part of the device.
We take a wire with a diameter of 3 mm.

With the help of nippers, we prepare segments of the required length (in my case, 60 cm).

Bend the segments in half.

We take a rail with a square section (I have 18 by 18 mm).
We cut segments along the width of the device (15 cm).

We make markings on the holes, based on 5 mm between the holes.

We make drilling.

And collect the "comb".






And then ... Oops !!! In the assembly process - a little nuisance.The wood was fragile.

But as they say "This trouble, we will survive."
Using a kapron thread, for reliability we wrap the edges of all the rails. Paste glue into the crack.

We bend the edges of the "comb" according to the angle of the side walls.
As a result, it turned out so.


All! It remains to assemble the details of the designer into a single whole.






And with a cheerful mood - “Go ahead for vitamins !!!”.
6.5
10
7.5

Add a comment

    • smilesmilesxaxaokdontknowyahoonea
      bossscratchfoolyesyes-yesaggressivesecret
      sorrydancedance2dance3pardonhelpdrinks
      stopfriendsgoodgoodgoodwhistleswoontongue
      smokeclappingcraydeclarederisivedon-t_mentiondownload
      heatirefullaugh1mdameetingmoskingnegative
      not_ipopcornpunishreadscarescaressearch
      tauntthank_youthisto_clueumnikacuteagree
      badbeeeblack_eyeblum3blushboastboredom
      censoredpleasantrysecret2threatenvictoryyusun_bespectacled
      shokrespektlolprevedwelcomekrutoyya_za
      ya_dobryihelperne_huliganne_othodifludbanclose
1 a comment
In childhood, too, with such went for blueberries. And now:

"When removing berries, it is forbidden to use various mechanical devices (scoops, combs, etc.). It is forbidden to remove lingonberries with unripe berries more than 1 percent of the collected mass; cranberry berries - more than 5 percent of the collected mass."

Article 15.26 of the Code of Administrative Offenses
Violation of the rules for the procurement, collection or purchase of mushrooms, other wild plants or parts thereof
.......
2. Violation of the established deadlines, the use of prohibited means or methods of collecting or harvesting mushrooms, other wild plants or parts thereof, or other violation of the rules for collecting or harvesting -
entail a warning or a fine of up to twenty base units, for an individual entrepreneur - up to one hundred base units, and for a legal entity - up to five hundred base units.

For reference: The base value is 21 rubles of the Republic of Belarus. At the moment, it's a little over ten dollars. In total, twenty basic ones - more than 200 tons of dollars! .... For the "comb" ....

We advise you to read:

Hand it for the smartphone ...