To make model an aircraft from ordinary ceiling tiles is quite real, you just need to follow the pattern exactly. The finished model of the aircraft has an original look, flight speed is not very fast. The assembled LASY BEE model has the following characteristics:
• wingspan 1.3 m;
• engine - hyperon 3019;
• 2 batteries at 1300 mAh;
• screw 11 * 8.
Materials and tools for homemade:
• ceiling tiles, can be purchased at any hardware store;
• adhesive tape;
• stationery knife;
• glue.
Aircraft Model Manufacturing Process
Step 1. Making the fuselage
According to the pattern, you need to make the basis of the aircraft, it will be necessary to accommodate the engine and batteries and other electronics.
Step 2. Steering wheel and wings
To make the elevator and turn rudder, you need to take a double layer of ceiling tiles and use a stationery knife to cut blanks as described in the drawing.
The width of the wing is 35 cm, the length of one half is 45 cm. It is not recommended to make a lower amplifier, because a rather sharp angle is obtained - it affects aerodynamics badly. A strip of scotch tape is glued on the front side of the wing, grooves need to be made on the inside, a regular fork is suitable for this procedure.
Step 3. Wing Assembly
First you need to glue the front of the wing, when it dries, proceed to the rear. To make the wing perfectly even, the rear edge must be glued on a flat surface. For gluing, it is necessary to install several stiffness strips to the wing edge.
This aircraft model has an even wing, however, it has three-channel control. In order not to have problems with control, the wing tip needs to be slightly raised up. The wingtips are cut out and attached at an angle to the wing, ribs must be installed on top of them.
Step 4. Final work
Plumage is mounted to the rear of the aircraft. Two servomotors and traction for them are mounted inside the base. In front of the fuselage, you need to install the wing holder, and then attach it.To prevent the gum from breaking the wing, it is recommended to strengthen it with another layer of the ceiling plate. The final step is to install a guide in the center and bottom of the model airplane.
Conclusion
A very good airplane model, if done correctly, the result will exceed all expectations. For beauty, LASY BEE can be decorated with different colors, so it will look even more impressive.
