Good day to all! To your attention an original LED night light. The material must be taken raw, since dry is very difficult to handle. In my case, a birch blank. Saw the workpiece into circles of about 2-3 cm and allow it to dry slightly in a bag of film, so that the workpieces do not crack. Next, you need to clean the circles with sandpaper so that they are smooth.
Then, in the center of the workpiece, draw a circle according to the template. Saw it with a jigsaw. We take glue and furniture pins with a diameter of 7 mm .. In the first two circles we drill three holes with a diameter of 6.5 mm and connect them lightly tapping with the addition of glue
Next, we drill the second circle with the third, the third with the fourth, so that the holes coincide in this way
The upper circle is not drilled to the end and in the upper one we do not cut out the central hole. We make the LED lamp from below. We attach an LED to the radiator and rivet an additional aluminum radiator.
I took a 3 W 12 V LED. When the diode is installed, glue a soft substrate to the base so as not to scratch furniture.
Turn on via the 12 V unit and enjoy a pleasant warm light. The diode must be taken with a warm glow.
I recommend this lamp to older people - it rejuvenates up to 40 years if you are 60!