He needs this.
Material: plastic sewer pipe 1.5 m, one corner to this pipe, one plug for this pipe, two wide clamps for fixing the pipe.
Tool: drill or screwdriver, drill No8, jigsaw with a sheet of metal (with a small tooth), core, marker or construction pencil (soft) wooden block (size approximately 10 cm by 6 cm), level.
The author took the pipe
dressed on one edge
on the second stub.
Then put a level on it
and made a marker with a marker
on both sides of the level
like this.
Then took the bar
and stepping back on the pipe 1 cm from the side of the plug,
began to do cross marking.
That's how the author did it.
Then he put the bar across,
and also drew a strip, these are the gaps that he will not cut out (Leave them for the strength of the pipe). The author will mark these squares with a cross so that they would not accidentally cut them out.
This is how the author looks like a pipe after marking.
He then outlined the core for drilling.
Drilled
the author cuts two sides from one hole.
So he goes.
The author uses wide clamps, as they are stronger.
According to the author, the size of the gap is not worth doing less.
Ka says the author can fix it on the floor with the help of wooden bars,
so on the wall. The author puts the clamps closer to the edges for structural strength.
The finished fixture looks like this.