I bought a new screwdriver, but there was no case for it and I decided to make a small box under it for convenient transportation.
To create a box I need plywood 10 mm thick.
Tool:
Screwdriver
Square
Clamps
Stapler for of furniture
Carpet
Glue
Hinges, lock, handle
Paint
To start, I mark out the plywood, set the required level on the cutting table.
Sawing plywood.
I process all the edges with sandpaper.
I mark where there will be holes for the screws.
I drill holes.
And fasten the sidewalls.
I use clamps.
I fasten the hinges of the lid.
The first fitting.
I unscrew the lid and start painting from the spray can with black paint.
I cut the Carpet into the size of a box and a lid.
I glue and shoot with a stapler for reliability.
I fasten a small partition.
I cut off a piece of rubber and fasten it to the side wall of the box and to the lid. It will be a bit holder.
I fasten the lock and handle.
The box is ready.
Thank you all for watching.