Question tinted car windows in home conditions are of interest to many. An important circumstance in this matter is compliance with state standards.
First you need to get a high-quality tint film, preferably metallized. On average, in Zhiguli, for example, 2.5-3 meters are needed. You also need a shampoo, 200 milliliters for the car will be enough. In a hardware store or supermarket, purchase a rubber eraser designed to displace water. Still need a sharp knife and razor blades. In addition, a spray gun is needed.
Rubber spatula eraser
If you decide to carry out the work efficiently, as in auto repair shops, then the glass must be removed. How this can be done is described in detail in the operating manual for your vehicle. Gently bring the glass home. Based on the size of the glass and an allowance of 5 centimeters around the perimeter, we begin to cut the film. Check if we have chosen the transparent side correctly. The film is cut on any glass sheet. It is best to start cutting films for small glasses.
Pour hot water into the container, preferably filtered, and add shampoo to the eye. With us we have blades, an eraser, a film. In order not to scratch or break the glass, you can put a sheet, or some non-fleecy rag. We carefully wash the glass. Then we take the blade (you can use it together with the machine for comfort) and begin processing the glass with the blade. Throughout its area you need to walk about two to three. When this procedure is completed, take the film and peel it off, disconnecting to the end. At the same time, it is necessary to constantly “puff” on the film so that it is wet. One, without the help of anyone, this procedure is quite difficult to perform. You can safely discard the remaining transparent film.
Apply the film with the adhesive side to the glass, gently holding it by the edges. Then you can exit the bathroom and, armed with an eraser, drive the water under the film to the edges. You do not need to press hard first. If the dirt suddenly clogged there, it may tear the film.Although after such a thorough washing in the steam rooms, dirt can hardly be present on the glass. Gradually increase the force of pressing and slowly continue to expel water. After about an hour, you can trim the edges of the film, but not completely. The edges can only be trimmed after 8 hours. In car services, freshly tinted windows direct the flow of hot air from dehumidifiers.
The angle of cut of the film to the glass should be 30 degrees. Do not forget that the blade must be extended. A dull blade will instantly provoke film tearing. On a fixed glass, the film is cut with a distance of 5 mm around the entire perimeter.
If you are tinting windows outside the house, then it is advisable to do this in wet weather and in a dustless environment.
Here are all the basic principles of tinting car windows with a film, which I wanted to set out.