» Electronics »Motion sensor to the kitchen

Motion sensor to the kitchen

Electronics
Added 2 commentary

Hello everybody.
I decided to make a motion sensor to turn on the LED strip, which is mounted on the kitchen set to illuminate the working area.

.

To do this, I need:
LED strip 5 m
12V power supply
Motion Sensor ()
Relay ()

Wires
Plastic bottle
Stationery knife
Ruler
Soldering iron

First cut the bottle


Bend from it a box to the size of the device and glue with hot glue

Then I solder all the details according to this scheme.

And put it in a box.


Next, I fasten the box with the sensor from the bottom to the upper kitchen drawer and connect it to the power and tape.



It turned out pretty well. The light turns on immediately upon entering the kitchen.
On the sensor, you can adjust the delay time of the glow of the tape and the sensitivity of the sensor.
Thank you all for watching.
10
10
6
11
Added 2 commentary

Add a comment

    • smilesmilesxaxaokdontknowyahoonea
      bossscratchfoolyesyes-yesaggressivesecret
      sorrydancedance2dance3pardonhelpdrinks
      stopfriendsgoodgoodgoodwhistleswoontongue
      smokeclappingcraydeclarederisivedon-t_mentiondownload
      heatirefullaugh1mdameetingmoskingnegative
      not_ipopcornpunishreadscarescaressearch
      tauntthank_youthisto_clueumnikacuteagree
      badbeeeblack_eyeblum3blushboastboredom
      censoredpleasantrysecret2threatenvictoryyusun_bespectacled
      shokrespektlolprevedwelcomekrutoyya_za
      ya_dobryihelperne_huliganne_othodifludbanclose
2 commentary
Author 0
Reply To quote A complaint
The photo shows that there is a refrigerator on the left side, therefore, sitting at the table the sensor is not visible and when no one is in the kitchen it does not turn on.
+1
Reply To quote A complaint
But isn’t it visible if you look at the working area while sitting?

DIY categories

We advise you to read:

Hand it for the smartphone ...