» Electronics » LEDs »Flashlight Glove

Flashlight glove


Hello everybody. If you need to repair something in car, connect the chandelier alone or do something where you need a good light, these flashlight gloves will always help you.

In order to make flashlight gloves, you need a construction glove, two 8 mm LEDs for a voltage of 3.7 volts, a flat lithium battery or a battery from a mobile phone, and of course the button is a switch with a lock. I soldered the resistor to the LEDs 30 ohms


Next, cut off the excess from the glove.

We fasten the LEDs on two fingers, and wrap the battery in the sleeve.


We connect the battery through the button with the bulbs .. diodes consume 0.125 mAh light is good you can see the whole place where you need to do something.



Of course it is more convenient when there are two such gloves .. on the right and on the left hand.
I applied soft wires, hid them inside the glove. I think apply it device on night fishing.
Thank you all for your attention.
1
1
1

Add a comment

    • smilesmilesxaxaokdontknowyahoonea
      bossscratchfoolyesyes-yesaggressivesecret
      sorrydancedance2dance3pardonhelpdrinks
      stopfriendsgoodgoodgoodwhistleswoontongue
      smokeclappingcraydeclarederisivedon-t_mentiondownload
      heatirefullaugh1mdameetingmoskingnegative
      not_ipopcornpunishreadscarescaressearch
      tauntthank_youthisto_clueumnikacuteagree
      badbeeeblack_eyeblum3blushboastboredom
      censoredpleasantrysecret2threatenvictoryyusun_bespectacled
      shokrespektlolprevedwelcomekrutoyya_za
      ya_dobryihelperne_huliganne_othodifludbanclose

We advise you to read:

Hand it for the smartphone ...