For such homemade thin and flexible metal will be required, an old hacksaw will do.
Or, like the author, an old square, of such a format.
The square is approximately 40 mm wide.
But such a metal has one feature, despite its flexibility and subtlety, it is very fragile.
To begin with, he will clean the metal of all unnecessary (old plaster and rust.)
Then he marked the place of the future bend.
And before bending, the author heats the place of the future bend to a bright cherry color.
And while hot metal neatly gives the desired shape.
Not allowing the metal to cool, until the desired shape is completely bent.
Then he cuts off the excess, as he took a blank with a margin. (A long workpiece is easier to bend.)
And the corrector makes the marking of future teeth.
Removes excess.
And straightens the teeth with a file.
After cutting off the workpiece completely.
Marks the desired length.
Then 14 mm retreats, (seven on the bend and seven on the spring foot.)
And the rest is cut off as unnecessary.
On the reverse side, he makes markings stepping back from the edge of 7 mm.
On this marking, the author made two marks stepping back from the sides of the workpiece of 12 mm.
Then from these marks makes lines in the direction of the teeth.
Like this.
Cut off excess.
The result was such a blank.
Then, in the center of the workpiece, the master drew a line.
And having retreated 18 mm from the curved edge, he turned the place of the future hole.
Then he made a hole.
Such steel is very difficult to drill, so it made a hole with a ceramic drill, after dipping it in grease.
Further from this hole, the author will make two thin slots.
Further, the part is well warmed up in this place.
Gives this part of the homemade product the desired shape.
Then warming up gives shape to the shank.
To prevent such an incident.
The part must be heated and bent at the same time.
Having made such paws out of a shank.
The author realized that they were too big and decided to cut them a couple of millimeters.
After well cleaned up homemade.
And painted.
Such a mount turned out.
Installing the finished mount.
Test.Such a mount, according to the author, can withstand 5 kg.
You can use such a mount for anything, everything will depend on your imagination.
If suddenly the mount does not put on the brick wall and is too loose on it, it can be adjusted with the paws, bending or vice versa unbending them.
And that's all for me. Thank you all and see you soon.