Hello everybody. Probably every child, teenager or adult man, dreamed of acquiring weapons gunshot, pneumatic, traumatic, etc. Unfortunately, gunshots are forbidden, traumatic permission is required. The only option is pneumatics, but here are the prices forpneumatics high. Although the principle of its action is very simple. Today I will show you how to make a simple air rifle. Well, it can’t be called full pneumatics, it’s experimental modelto show how air guns work. I did this homemade from unnecessary trash that I found in the barn. I do not bear any responsibility, only you are responsible for all your actions. Although this is a little thing (let's call it that), you still need to be careful. Well then, let's get started.
To make this homemade, we need
1. Stainless steel pipe (I decided to make the rifle heavier, but you can choose a PVC pipe or something else)
2. Faucet (you can also use PVC faucet)
3. Adapter and found in the barn device I don’t know why. This device is made of two couplings and of two adapters from a hose to a faucet. You can use that other.
4. Nut
5. Sealant
Step 1. Fasten the bottle to the adapter
At this stage, you need to fix the bottle cap on the adapter. It is necessary to fasten so that air is not allowed anywhere. First, I made a gasket from the camera, put it on the adapter, on top of it another factory gasket (I found only one factory gasket, so I had to make one more from the camera). We make a hole on the cover and put it on the adapter. We tighten the gasket and tighten the cover with a bolt. We make a hole in the bottle and glue the nickel on the inside, and a gasket to the top with an adhesion. The gasket should be pressed firmly against the nipple. Then we hammer the adapter into the coupling with a hammer.
Step 2: trunk
Now it remains to make the trunk. For the barrel used stainless steel pipe. I used another faucet with a welded tube on the end. This pipe fit almost perfectly into the stainless steel pipe.I applied sealant to the faucet tube and drove the tube into the pipe. The barrel is ready, now it remains to connect both parts (barrel and bottle) we fasten the faucet, as seen in the photo.
Step 3. Test
That's all now left to test pneumatics. For shooting, I used an ear of corn, just throw it into the tube and shoot. Instead of an ear, you can use paper or something else. It turned out pneumatics, well, it's more of a fart or a toy. It shoots on the cob, 20-25 meters. This is far from full pneumatics. But maybe you all understood the principle of work. If not, then I’ll explain that air is pumped into the bottle by the pump, the ear is inserted into the barrel, and by abruptly opening the tap air presses the ear under pressure. And finally, I fastened the bottle and adapter with adhesive tape for greater reliability. I hope you enjoyed the homemade. Thanks for watching, we like.