Friends, I want to talk about the construction of an interesting aircraft model. Looking through photos of new spacecraft, I liked the design of the new space planes.
And then this drawing caught my eye.
So I decided to build something similar.
No drawings. A vague image of a model arises in my imagination.
First looked electronicsthat is available.
Two motors were lying around and the screws were small.
Here the size is calculated for them.
Everything is done like that - looked and cut out. Drove to the place - glued. Complete improvisation. I myself did not know what would come of it.
In the head is the wind. So the name naturally appeared in the model - "Wind".
I cut a supporting wing from the ceiling, of a regular, triangular shape.
On this wing glued the sides of the fuselage. I glued on top of the cabin, which I cut out of a plastic bottle.
He cut the keels, tried on and glued.
For fastening motors glued pieces of insulation "penoplex", which glued plywood size 40 x40 mm. Motors will be attached to them.
Glued the side walls of the ducts. From above it all closes with a lid and looks like this.
Installed motors, hung elevons, mounted servos, glued boars, connected rods.
Pulled over model colored tape.
All! The model is ready.
Materials
Ceiling tile (ceiling) - 4 mm.
Universal adhesive, moisture resistant - "Titanium".
Colored tape.
TTX.
Length - 1100 mm.
Span -.900 mm.
Weight (flight) - 550 g.
Motra - AH-3208N 1100.
Test data:
Battery: 11.5v
Current: 9.7A
Propeller: 8x3.8
Thrust: 550g
Screws - 4 x 4.5 three-blade, multidirectional - 2 pcs.
Regulators 40A. - 2 pcs.
The battery is 1300 3S.
Servos - NHT900.
My screws are a little smaller and the thrust will also be less, but considering that there are three-blade screws and two of them, the thrust should be enough.
Model on pre-launch verification.
And, of course, a selfie with a model.
See you soon! IN..