Greetings to all lovers of crafting something from nothing.
Today we will make easy to manufacture, but useful homemade, which will help to find a puncture place in the tire of a bicycle, moped, motorcycle, etc.
Tools needed.
1. Electric drill.
2. Glue gun.
3. Knife
4. Scissors.
Materials and consumables needed.
1. Two containers for analysis.
2. Mosquito net.
3. Polyfoam.
4. Sandpaper.
For the manufacture of this homemade product, we used two containers for analysis, of course you can make one, but the two are much more accurate. In the beginning, they wanted to use a package of toothpicks, but the plastic from which it is made is very fragile and bursts during operation, which can not be said about containers.
The bottom was cut from one container and several holes were drilled in it. Holes can also be burned with a heated needle. From the second container we only need a lid.
Mark the hole in the lid and cut it with a knife.
The unevenness of the cut is cleaned with sandpaper.
Now mark the mosquito net on the bottom of the first container and cut with scissors.
We insert the cut mosquito net into the lid of the container and fasten it with a glue gun. Super glue also works.
We divide a piece of foam into separate balls and fill them with the resulting capacity by about two-thirds of the volume.
Close the lid and glue everything together.
Device done.
Now a little about usage.
The puncture place in the bicycle tire, according to tradition, is determined by immersion in water.
And if such a nuisance happened on the road, far from the reservoir, then this device will help you.
We spend this device on the surface of the inflated tire and at the puncture site, the foam balls begin to bounce.
We glue the patch and again on the road.
All good and not a nail or rod.
A video about making homemade products can be seen here.