» Modeling » Aviation "Red model"!

Air model "Red"!

Hello dear lovers homemade and aircraft models in particular. Today I want to tell you about an interesting aircraft model - aerobatics, which the author created, long hatching the idea of ​​creating such an aircraft model.


The author, apparently, took as a basis the drawings of a standard aerobatic aircraft model and simply adjusted the size to the ceiling tiles.

The author applied the following materials during construction:
ceiling tile (I think that you can apply a ceiling of any thickness),
wooden, student rulers,
color adhesive tape.
Glue can be applied to any moisture resistant, universal for gluing ceiling tiles.
Paper clips, pieces of aluminum from a can of beer, for making loops on the cockpit lantern.
For the manufacture of bowden, in which the traction passes, you can use any plastic tubes (from Chip-Chups candies, cocktail).

The author gives little explanation for his photographs, I will try to correct this omission.
All construction The model begins, as always, with the drawings.

The author suggested starting the assembly of the aircraft model with the installation of the fuselage.



Try on the tail.




We glue a piece of plywood or fiberboard for mounting the motor.

Assembly of the wings.

The frame for the cab lantern is glued together.



The covering of various parts of the aircraft model with colored tape begins.



Mounting the cockpit lantern to the fuselage.


Install the motor.

Glue the rear crutch into the rear of the fuselage.

To mount the wings to the fuselage, a wooden ruler is glued.

Making loops for steering wheels.


Mounted traction on the electron.

Trying on a pilot figure.


Model ready and asks for flight.


The author said that the wings were not quite a good profile, and he redid them. So, keep this in mind and immediately make the wings of the desired profile. The mistake was in a very pointed forehead of the wing.


Making new wings with a modified profile. The wing forehead is made rounded.


Decorative inscriptions are made and winglets are glued to the ends of the wings.







A few words about the characteristics of the model.
Span - 780 mm,
Length - 560 mm
Weight - 350 - 390 g. (Depends on the battery).
I put this on my model electronics:
Motor - 2212 1400kv.
Regulator -4oA.
The battery is 3S 1300.
Servos - MG90S.
This is my model, built after reading the author’s article.


Video of the author.

So my story came up about an aircraft model called "Red" !.
I wish you successful construction and flying around the new model.
Goodbye, see you later bgm.imdmyself.com.
Your Valerian master.
7.6
7.6
8

Add a comment

    • smilesmilesxaxaokdontknowyahoonea
      bossscratchfoolyesyes-yesaggressivesecret
      sorrydancedance2dance3pardonhelpdrinks
      stopfriendsgoodgoodgoodwhistleswoontongue
      smokeclappingcraydeclarederisivedon-t_mentiondownload
      heatirefullaugh1mdameetingmoskingnegative
      not_ipopcornpunishreadscarescaressearch
      tauntthank_youthisto_clueumnikacuteagree
      badbeeeblack_eyeblum3blushboastboredom
      censoredpleasantrysecret2threatenvictoryyusun_bespectacled
      shokrespektlolprevedwelcomekrutoyya_za
      ya_dobryihelperne_huliganne_othodifludbanclose

We advise you to read:

Hand it for the smartphone ...