Model It has a very exotic name "Bird of Prey, although the author calls it - Bird of Prayer.
Schematic drawing of the model.
The author begins construction from the bow of the fuselage
The middle part of the fuselage is cut out, tried on and glued together.
Partitions are cut out and tried on, in which the impeller will be installed.
The inlet of the duct located in front of the impeller is cut out and adjusted in place.
The air duct located behind the impellers is cut out and glued.
Mount the rear wings of the stabilizer. During installation, a carbon tube is used, in which 2 mm pieces are inserted. wires glued to the stabilizer. To do this, grooves are cut out in the stabilizer.
The back of the upper fuselage wall is glued.
Carbon tubes are glued into the main wings for strength.
Goes to the top of the fuselage.
This is how the model looks at this stage.
The upper casing of the fuselage.
Ready model.
Servos are installed.
The impeller inlet panel is cut out.
A lid is being made into the battery compartment.
The nose of the fuselage is set in place.
The model has acquired a finished look. You can start tight-fitting with colored tape.
Final result
The same model can be made with two impellers.
Video of the first flight.
Dimensions of the model.
Span - 760 mm
Length - 960 mm
Good luck in building the model, pleasant flights and soft landings.
On this, let me say goodbye to you.
Bye.
Your valerian.