Hello dear guests.
I can not resist the temptation, and show the wonderful transformation of the Polaris aircraft model.
The author, according to the records of which I tell you about the construction of these models, always amazes with her extraordinary imagination. So this time he carried me away with his improvisations on the theme of a famous model.
His first model, the author called - "Dualis."
As always, the author begins with drawings and drawings.
Almost all structural elements are reinforced with carbon rods or tubes.
In the center of the carrier platform, a plywood is glued with an integrated metal workpiece with thread for fastening the replaceable wings.
On the edge of the side walls of the fuselage, ceiling strips are glued.
Mounted fuselage.
The wing blank is cut into two halves and plywood blanks are glued into them for attaching the wing in the fuselage.
Installation of the fuselage continues.
The walk-behind tractor is glued.
Preparations are made for the keel.
Everything is adjusted in place, cleaned and glued.
Servos are installed to control the LV and RV, wires are laid ..
Local tightening with colored tape begins.
The motor is installed and electronics.
Here is a model with interchangeable wings.
Video flight of this model.
The author does not stop in his experiments and he has an idea to make wings with variable geometry on this model. The author gave the name of this model - Dualis SW (Swing-Wing hinged wing).
Here is the electronics the author offers for models.
Motor: - D2826-6 2200kv
Screw -t 6x4E.
The battery is 3S. 1800mAh 20C
The regulator is 40A.
Wing Control Servos - Turnigy_S3317M ...
Servos -: HXT900 9 g / 1.6 kg / 0.12 s ...
The author paid much attention to drawings and drawings. Detailed developmental layouts of all the structural elements of the model are given. I wanted to reduce the number of photos, but upon careful consideration of them, I came to the conclusion that all photos are important. Each of them shows the next stage of the model construction. You can choose the scale, affix dimensions and make a model.
I will not dwell on the assembly of the fuselage in detail, all stages of installation are the same as on the previous model.
The main difference of this model is the sliding wings.
For better glide, the workpieces are covered with transparent tape and heated with an iron.
The mounting locations of the servos are marked and they are glued.
Rotary washers are installed.
Ready wings are mounted.
For servos, the shoulders of the rocking chairs increase.
Servos for pH elevons are mounted.
The model has acquired a finished look.
Video flight model with variable wing geometry.
Dear friends, I hope you liked my story and you became interested in building such aircraft models. Success in building and flying around new models.
Bye. Your valerian.