» Aliexpress » Tools and fixtures »Stack loop for modeling

Loop stacks for modeling


Such stacks are useful when modeling from ceramics, wax, polymer clay, plasticine, etc. Using them, you can create a variety of patterns on the surface or remove excess material from the cut figures. These stacks are a handle with double-edged loops pressed into the end. The handle of the stacks is covered with anti-slip notches, so that during operation they will not slip out of the hands. The cutting part is quite rigid, does not change or stagger when working. The stacks are quite light, almost not felt in the hand. These tools are made entirely of aluminum alloy. The length of each stack is a little over 120 mm. The kit includes 6 cutters of various shapes, supplied in a proprietary plastic packaging. If stacks of a different form are required, attention can be paid to this lot - it presents similar tools with wooden handles.

Pretty good tools for precision work. The quality of their manufacture is at a fairly high level, there are no burrs. Of the minuses, we can only highlight that the cutting part is not always perfectly sharpened and for this reason it is recommended to correct it (for example, sandpaper) for the best result. Note also that, given the current discount, the entire set can be obtained for a symbolic 7 rubles.
Loop stacks for modeling

Cost: ~ 175

Add a comment

    • smilesmilesxaxaokdontknowyahoonea
      bossscratchfoolyesyes-yesaggressivesecret
      sorrydancedance2dance3pardonhelpdrinks
      stopfriendsgoodgoodgoodwhistleswoontongue
      smokeclappingcraydeclarederisivedon-t_mentiondownload
      heatirefullaugh1mdameetingmoskingnegative
      not_ipopcornpunishreadscarescaressearch
      tauntthank_youthisto_clueumnikacuteagree
      badbeeeblack_eyeblum3blushboastboredom
      censoredpleasantrysecret2threatenvictoryyusun_bespectacled
      shokrespektlolprevedwelcomekrutoyya_za
      ya_dobryihelperne_huliganne_othodifludbanclose

We advise you to read:

Hand it for the smartphone ...