Hello, model aircraft, hello, hello!
Author, construction the models of which I will now show, it never ceases to amaze me not only with its talent in building models, but also with its unbridled imagination, which is sometimes ahead of the latest developments of modern aircraft designers in the world.
The Swedish Air Force is planning to create an invisibility fighter project only by 2020, and the author is already doing model like an airplane.
Flight System 2020, abbreviated FS 2020
Before constructing this model, the author makes a lot of drawings of the model from various angles, looking at which, you can completely build a similar model for us, especially since the author shows photos of the process of building the model.
The fuselage carrier platform is being manufactured.
Before shaping the fuselage, the workpiece is covered with transparent tape.
To save the desired shape of the workpiece, you can use paper, masking tape.
The billet is rolled, measured and the adhesive tape is removed.
Gluing the fuselage.
Fitting individual parts of the fuselage.
Installation of the duct.
Gluing the upper surface of the fuselage.
Production and pasting of a cabin.
Servo installation location.
A hatch is made into the battery compartment.
Canard is glued with a lightweight fiberglass cloth.
Trying on electronics and battery.
A tail cone is installed.
The appearance of the model.
Ventilation holes and cover removal hole.
Ready model.
Primer model.
The final coloring of the model.
The author decided, for greater travel stability, to make two keels on the underside of the fuselage.
Video flight.
I told everything about this model, but I wanted to tell in a nutshell about another interesting model of this author.
It will be about the model SR-71 Black Bird - Black Bird. You can read more about this model in the author’s blog at the source link.
Almost the entire model consists of two halves - the upper and lower.
A spar is glued inside one of the halves, which can be made of a student’s wooden
rulers or wooden slats. Stiffeners are made of a ceiling (substrate) and glued to the rib.
Details before bending them, to give the desired shape, are covered with transparent tape.
Keels are made of two layers and strengthened inside with a wooden slider - a ruler.
In the finished hoods for engines. Slots are made for gluing keels.
Before gluing both halves of the model, all the electronics are mounted.
For quick access to it and into the battery compartment, a hatch is made.
Elevons are mounted, traction is connected, motors are mounted.
The author turned out to be rather a white bird, but it flies beautifully.
To launch from the ground, the author plans to put the chassis.
Video flight.
This is where I end my story.
Goodbye, your valerian.