» Modeling » Auto Moto »A motorcycle of 2 lighters with your own hands

DIY motorcycle lighter with 2 lighters

Is it possible do it yourself to make lighters from the parts of two old motorcycle? You can and in just half an hour!
DIY motorcycle lighter with 2 lighters

Making this crafts for a person who first encounters miniature works, it will be a little complicated. We all have this first time. Without fear and doubt, we take up the job.

It will take the very minimum:
1 - two lighters worked out without gas;
2 - a little epoxy putty (or other polymer hardening materials);
3 - from tools: a sharp knife, an awl, a round file.

First of all, until the last screw-bolt, we disassemble the lighters. Only the casings themselves (sprays) remain worthless. As a safety measure, I remind you that only fully used lighters are taken! If you want to do this from new ones, then first release gas from them!

The photo shows what parts were obtained as a result of disassembly, their quantity and appearance. We are engaged in the steering column of a motorcycle. For this, the head of the lighter is used, in the rack of which a hole is drilled. Practically - pierced with an awl and bored with a file for installing steering wheel parts.

The push lever is installed

The front wing and fairing of the motorcycle are made of metal frames of the head part of the lighter.

The steering wheel is assembled from gas supply pipes and springs

Install it in the hole on the glue

Two valves stick to the fairing and will play the role of headlights

We pass to the rear of the motorcycle. The second lighter head is used here. We collect silencers

Glue them in their place. We also make a hole in the rack.

From a piece of wire and a spring, the rear seat back is made


It turned out two halves of the motorcycle, which must be combined into one. An epoxy putty is prepared for this purpose. To get a black color, you need to add soot or dry Chinese mascara to it. Putty on both halves of the motorcycle, giving it the shape of a saddle. We press the shock absorbers of the rear wheel and the engine (this is visible in the photo) and let the putty harden.



Your craft is ready!



Good luck to you! Follow the rules of the road! : bully:
10
10
10

Add a comment

    • smilesmilesxaxaokdontknowyahoonea
      bossscratchfoolyesyes-yesaggressivesecret
      sorrydancedance2dance3pardonhelpdrinks
      stopfriendsgoodgoodgoodwhistleswoontongue
      smokeclappingcraydeclarederisivedon-t_mentiondownload
      heatirefullaugh1mdameetingmoskingnegative
      not_ipopcornpunishreadscarescaressearch
      tauntthank_youthisto_clueumnikacuteagree
      badbeeeblack_eyeblum3blushboastboredom
      censoredpleasantrysecret2threatenvictoryyusun_bespectacled
      shokrespektlolprevedwelcomekrutoyya_za
      ya_dobryihelperne_huliganne_othodifludbanclose

We advise you to read:

Hand it for the smartphone ...