» Fixtures » Apparatus »Homemade alcohol factory do it yourself

DIY homemade alcohol factory

DIY homemade alcohol factory

Of course, alcohol is a good and indispensable thing in medicine, and you can buy it at any pharmacy. But for greater interest, people figured out how to make a device with their own hands that would make this “elixir”. It should be noted that perhaps everyone would like to construct such a technique, but only a few know how to do this.

In order to make it home alcohol factory, you will need:
• Galvanized bucket. For these purposes, the old will do. The main thing is to have a whole. It is very important!
• Two meters of copper tube
• Clamp and a few bolts
• Cold welding
• Aluminum can. If there is no can, a pan will do.
• Several nuts
• Silicone based gasket
• Screw ties
• wire
• Drill

Well, now, with all your imagination, you can begin to manufacture this miracle.

On the cylinder, it is necessary to roll a pre-prepared tube into a ring. At the same time, remember that straight ends must remain so that steam can freely enter and exit. Thus, you will get a certain coil.

Now in the wall of the bucket, next to the base, drill a small hole. The size should be such that the tube can freely pass through it. But don't hang out.

Next, pass the lower end of the tube through the hole, but the upper one must be secured with a clamp and a few bolts. By the way, in order to make the outlet of the lower end of the tube more tight, you can solder it. Another option is allowed. You can just coat it with cold welding.

That's all. In general, the alcohol device is ready. Next, you need to build a distillation cube. After which, you can safely connect it to the device itself.

So, take the can, or rather, its lid and cut the fitting. Now, secure it with the nuts and silicone gasket.

Next, you need to seal the lid. Remember that rubber is not suitable for these purposes. It is necessary to fill the inner recess of the lid with a silicone gasket.

Press the cover with the wire. To do this, pass it into the lid ear, and connect the ends, together with the handles, with the other end of the wire.

Now you can connect the device to the pan.

As many have noticed, doing all this is very simple and not difficult. At first glance, it may seem that all this is unrealistic. But in fact, nowhere is easier. Try it, and everything will work out.
8.5
5.5
6

Add a comment

    • smilesmilesxaxaokdontknowyahoonea
      bossscratchfoolyesyes-yesaggressivesecret
      sorrydancedance2dance3pardonhelpdrinks
      stopfriendsgoodgoodgoodwhistleswoontongue
      smokeclappingcraydeclarederisivedon-t_mentiondownload
      heatirefullaugh1mdameetingmoskingnegative
      not_ipopcornpunishreadscarescaressearch
      tauntthank_youthisto_clueumnikacuteagree
      badbeeeblack_eyeblum3blushboastboredom
      censoredpleasantrysecret2threatenvictoryyusun_bespectacled
      shokrespektlolprevedwelcomekrutoyya_za
      ya_dobryihelperne_huliganne_othodifludbanclose

We advise you to read:

Hand it for the smartphone ...