Introducing the next homemade weapons themes. This time we will make a pneumatic machine gun.
Let's start with the author’s video
So we need:
- siphon for water aeration;
- drill or screwdriver;
- nipple from tubeless tire;
- 60 ml syringe;
- glue gun;
- plastic tube;
- bolt
We turn off the siphon cover, remove all the contents and drill a hole in the bottom, into which we install a nipple from a tubeless tire. The author uses a conventional nipple, so he seals it with ordinary rubber.
Putting the siphon back.
Next, take a 60 ml syringe and drill a hole on the side.
We insert the nozzle from the siphon into the hole made.
We strengthen everything with hot glue, which will also make the structure tight.
The tube can be removed from the can of foam. The diameter of such a tube is ideal for plastic bullets.
Next, shorten the spitz nose and insert a tube in its place.
Using the bolt, add the trigger lever, as shown in the figure below.
In the end, if desired, paint the entire structure with spray paint.
To charge our machine gun, it is enough to open the piston of the syringe and pour cartridges into it. Next, we take the pump and pump our capacity with compressed air. Opening the lever, air will enter the syringe and the balls will fly out of the syringe.