We will need:
1. Food containers.
2. Hot melt adhesive.
3. Nylon thread (thin wire or ordinary thread).
4. Scissors.
Step # 1:
Cut the containers as shown in the picture. If the plastic is soft, then you can use scissors, otherwise a cutter, knife or a heated awl (to melt).
We will need these parts.
Step number 2:
Puncture holes in the indicated places (it is best to melt them with a heated awl).
Step number 3:
Attach cylinder No. 1 to the paper with the upper circle and circle. With a thread, mark the crosshair through the center of the circle and fix the ends with tape. Apply hot melt glue to the thread. After cooling the glue, separate the resulting cross from the paper (this will be easier to do if you first put strips of tape on the paper, this will not stick the paper to the delicate part).
Repeat step # 3 with the bottom circumference of the first cylinder and the bottom circumference of the second cylinder. The result is three crosshairs:
Step 4:
Through the holes in the cylinders we thread the rope ends of the crosshairs and fix with glue.
Be careful not to confuse the crosshairs!
Insert the first cylinder with the narrow end into the second and fasten with a central thread (it turns out that the middle cross falls on two cylinders).
Step number 5:
It remains only to trim the ends of the threads (preferably 5 mm each) and set them on fire.
[/ center]
The bottom fits perfectly from the bottom and does not crash. This was done so that draining water can be drained and it does not drip onto the table after washing the cutlery. If you do not need this, then you can pierce several holes with a heated awl.
Thanks for attention!