For this tool, the author needed: a profile pipe is not a big piece, an electric motor, sheet metal No. 4 from it, the author cut out a file holder and a frame for a jigsaw, he also needs blades for a jigsaw, bolts with wing nuts, washers and a still small piece of sheet metal No. 2 -3 for mounting the motor.
The author will connect the saw holder and the profile pipe together
for this he will make a hole in these details
under the bolt
Then the motor mounts will be welded to the profile pipe
thus
Then he made a hole for attaching the paintings in the holder
inserted bolts into the holes and grabbed them with welding
But before welding the lower bolt, he put the part from the profile pipe and the motor mount in its place.
Then the author tried on the canvas
Then he stretched the canvas and fixed it with wing nuts.
Then he drilled a hole in the center of the bed
then set the bed by threading the canvas through the hole
and welded it to the profile pipe
Then he strengthened the motor.
Further, the author has carved such a wheel
then drilled a hole in it
and put a screw into this hole
Thus, the author turned out an eccentric shaft. He put this shaft on the axis of the motor.
By the next step, the author drilled a hole in the connecting rod holder
He used steel wire as a connecting rod
made one turn of wire around the cam
then bent one edge of the wire in this way and passed it into the hole on the holder
He took a bite too much.
Then he soldered the power to the motor and the author made such a jigsaw.
And in the end, the author made a tool test for performance.
Video: