In this article, the author of the izzy swan YouTube channel will tell you how he made a simple coordinate table for the router.
It all started with an ordinary children's toy, which with two pens draws on the screen.
Materials
- sheet plywood
- Bolts, nuts, washers M8
- Wood screws with press washer
- Steel bar 8 mm in diameter
- Steel cable.
Instruments, used by the author.
- Manual frezer
- Screwdriver
- Drilling machine, wood crowns
- Milling machine
- Square, pencil.
Manufacturing process.
To begin with, the author cuts several rounds from sheet plywood.
Then, in such a simple way, the grooves are milled in them. Thus, the author produced guide rollers.
Marks the future base of the coordinate table. A plywood sheet is suitable for this.
Then he drills holes for the mounting bolts.
From the wooden round timber the master made stands for the rollers, screwed them to the base.
Then begins to install the rollers.
The next step is pulling steel cables.
You can check the operation of the cables in both horizontal coordinates.
As guides, the author will use a steel bar.
Starts assembling guides and sliders, as well as adjusting knobs.
Now sets the center part. Everything is already moving.
Tightens the clamp to the central part, installs a milling cutter in it without a sole. And here is the third axis - vertical adjustment of the cutter in height ..
Screws a plywood blank to the table, turns on the milling cutter, then lowers it, and can be cut.
Here is such an interesting table from the author.
Thanks to the author for an interesting carpentry device!
All good mood, good luck, and interesting ideas!