On the Parkfire channel, I saw a series of videos about this model.
I was eager to collect myself such a coach.
He wanted to do according to the drawings that were proposed and the photographs, but hesitated.
I took several photos of the model in three-dimensional format, took advantage of them, put down the dimensions and started working. For clarity, I used drawings. Looking at these pictures model even a novice modeler who has no experience building models can collect.
Applicable materials.
A simple substrate for a laminate, blue, smooth on both sides, without rust.
Heater "Penopleks".
Universal glue, moisture resistant - "CIN".
Colored adhesive tape.
At first, as usual, I cut out all the details. He dumped everything in one heap and later ripped out the necessary details. This is my laziness!
He tried on, adjusted in place and glued.
He began, as always, with the wing.
My wing did not cause any difficulties. We bend the workpiece, inside previously gluing the spar from the insulation strip, along the entire length of the wing and glue it.
For me, the most difficult element was a pencil case - the fuselage. It is made of two parts that are inserted one into the other and a box is obtained in which the whole electronics. Electronics. On the front of one of the halves of the fuselage, a piece of insulation was pasted, with a piece of hardboard (MDF) glued onto it, measuring 40 x 40 mm. Here the motor will be mounted.
In the process, I fit the model with colored tape. I put the servos, attach the elevons, paste the boars, connect the rods.
Installed a motor and chassis. Wheels took ready, littered with old models. Racks made of aluminum strip with a cross section of 15 x 2 mm. The wheels are bolted to the struts with long bolts. .
After installing the electronics and the battery, the lower part of the fuselage is inserted into the upper, stationary part and fixed with wooden studs. - with toothpicks.
Before the flight, I glue the joints of the halves of the fuselage with pieces of transparent tape.
Motor - 3010 300Kv.
Screw - 8 x 6 three-blade.
The regulator is 40 A.
The battery is 2200 3S.
Servos - MG9S.
While doing this aircraft model, made wings for a broken model of a gyroplane, put it on instead of the propeller blades.
Rotor Blades -: 821 mm.
Length - 795 mm.
Height - 392 mm.
Weight: 600g
Regulator - 20A
Servos - 9g x 4 pcs.
Motor - 800KV brushless outrunner
The result was a very interesting model
