The site has several homemade of this master, "Nursery "for young birds (brooder), "A very simple incubator", "The device for turning eggs - 2" other. In this article, we will consider his next homemade product in the field of poultry farming. The egg tray is attached to the device at an angle of 45 degrees. When the tray rotates around the axis, the eggs rotate in one and the other direction. Of course, this does not replace the need for a complete egg roll, but it will have a beneficial effect on the process of chickens.
Tools and materials:
MDF;
-Bearing;
-Fasteners;
-Board;
-Motor reducer;
- Tray for eggs;
-Roulette;
-Hacksaw;
-Marker;
-A screwdriver;
- Feather drill;
-Glue gun;
Step One: Turntable
From the MDF cuts a circle. A hole is drilled in the center of the circle.
Step Two: Axis
Installs a bolt in the hole and fixes it with a nut.
Step Three: Bearing
In the bar, drills a hole along the diameter of the bearing. It installs the bearing and fixes it with screws and hot glue on three sides.
Step Four: Gear Motor
Fastens a PVC cap to the axis. Inserts the motor shaft into the cap and fixes them with a screw.
Step Five: Platform
It makes a platform with a plane of 45 degrees from MDF and boards. Secures the engine.
Step Six: Tray
Turns the tray backside and secures it to the turntable.
Now it remains to lay the eggs in the cells and install in the incubator.
The complete assembly of the device can be seen in the video.