If someone thinks that making a tap holder do it yourself - the process is very time-consuming and costly, it is deeply mistaken. To make this fixtures we need only five minutes of time and a few junk parts that are always at hand from any artisan.
Available in manufacture it is even fifth grader.
Video instruction
We will need tools: Drill, vise, drill, center punch.
Materials needed: Three nuts, two bolts, and heat shrink tubing.
Manufacturing process:
- We drill a long nut in the center.
- We put heat-shrink tubing on the bolts.
- We heat the pipes until they completely shrink.
- We collect the device.
- We cut the thread.
Good luck friends.