Running in water and swamp. video
The performance characteristics car making:
1) The engine "Lifan" with a capacity of 7 liters. from.
2) Clutch belt.
3) Transmission gearbox from the Opel four-speed.
4) The final drive from the Luaz car.
5) The rear axle from the VAZ-2105 is used.
6) Turn by triggering the differential.
7) Drum brakes, brake master cylinders are installed from the VAZ-2106 clutch
8) The hull of the boat is riveted.
9) The caterpillar is made on the basis of a conveyor belt 6 mm thick, 440 mm wide.
10) The tracks are made from a corner of 25x25x3 mm.
11) Fangs are made of a strip of 25x4 and 20x4 mm.
Dimensions of the all-terrain vehicle:
Length is 2000 mm.
Width is 1760 mm.
The width of the boat is 700 mm.
The length of the boat is 2000 mm.
The height of the boat is 570 mm.
Fangs prevent caterpillars from coming off the drive wheel during rides and turns.
Sizes of fangs. Height is 75 mm.
The caterpillar is assembled.
The width between the two conveyor belts is 150 mm, should be slightly larger than the width of the drive and support wheels.
Lugs are welded to the tracks.
The caterpillar is dressed on wheels.
A third axis is welded in the middle of the boat for mounting the support wheel.
The axis is welded 5 cm below the axles of the drive and idler wheels, which has led to improved turns on hard ground without unnecessary effort.
The length of the caterpillar did not increase.
The sagging of the tracks decreased, and the additional support reduced the longitudinal swing of the tracks during the ride.
The frame is welded and all mechanisms are installed, which made it possible to break-in.
Running-in engine idling. video
The engine is installed.
The engine control is displayed on the levers.
Engine management. video
The boat is riveted.
A place for a spare wheel is also available.
Included in trailer.
To the place of further operation and break-in.
The weight of the car made about 300 kg.
Break-in moment.video